Enhance the performance of your Yamaha G29/Drive with the 36/48V 440 Amp 19-Spline High Speed Motor and Controller Kit, built for stronger acceleration and increased top-end speed. This well-matched setup features a dependable 440-amp controller and a durable high-speed motor, delivering smooth, efficient, and consistent power. A 48V solenoid is also included, providing reliable power engagement and helping simplify installation.

Motor Features:

• Yamaha G29/Drive 48 volt high speed motor
• Works with Yamaha G19 or G22, but speed sensor plug may need to be sourced from OEM motor
• 19-spline coupler
• Includes a 1-year warranty
• With upgraded controller:
  • Speed up to 23 mph at 48 volts
  • Up to 25% increase in torque
  • 10 HP Peak

Controller Features:

• TSX 3.0 440AMP 36-48V Bluetooth Controller
• The Navitas app allows you to monitor the vehicle's performance
  • Built-in speedometer
  • Gear indicator (Forward, Neutral, Reverse)
  • One-click Car Lock Out feature
  • Live battery voltage monitoring
  • Provides alerts that you can send directly to your technician/dealer by email
• New "Cruise mode" for higher top speed (Up to 15% faster)
  • Speeds up to 23 mph with stock 18" tires
  • Lower Speeds = Greater Range
• Up to 75% more raw power. Improved hill climb capability with 22/23" tires
• Use your stock motor, solenoid and existing wiring
• Plug and play installation
• Control your regen braking in forward and reverse for added safety when driving or backing down inclines
• Use the "lock out feature" to lock in settings to control power and speed

Kit Includes:

• Navitas TSX3.0 440A 36-48V DC Controller - 25-047
• Yamaha G29/Drive TSX Harness - 31926
• Bolt 48V HD Solenoid (36V Compatible) - 33-001
• Reliance Yamaha G29/Drive 19-Spline High Speed Motor - 25-517

New Motor Break-In Instructions:

Follow these steps carefully:

• 1. Initial Drive: Drive the vehicle for 8–10 miles at varying speeds, taking care to accelerate gently during this period.
• 2. Temperature Monitoring:
  • Drive on a level surface, such as pavement or asphalt. Gradually accelerate and maintain full speed for 5–10 minutes. Then, stop and check the motor temperature.
  • During the first 30 minutes of use, check the motor temperature every 10 minutes. To do this, touch the center section of the motor near the aluminum end bell (silver component).
  • If the aluminum end bell is too hot to touch, stop using the motor and allow it to cool down.
  • If you can hold your hand on the motor for more than 5 seconds, it is safe to continue driving for a few more miles before rechecking the temperature. Repeat steps 1 and 2 until the 8-10 mile break-in period is completed and the motor operates at a cooler temperature. Following this process will help ensure your electric motor is properly conditioned for long-term use.
• CAUTION: Exercise caution while checking the motor. Avoid touching any exposed electrical connections while the power is on.