Yamaha G29/Drive 36/48V 440Amp 19-Spline High Torque Motor and Controller Kit
Yamaha G29/Drive 36/48V 440Amp 19-Spline High Torque Motor and Controller Kit
Out of stock
Free Shipping
Item #:25-610
$2,014.99$3,024.95You Save: $1,009.96
Enhance the power and drivability of your Yamaha G29/Drive with the 36/48V 440 Amp 19-Spline High Torque Motor and Controller Kit, built for stronger low-end performance. This setup delivers impressive acceleration, better hill-climbing capability, and smooth, controlled power output. Featuring a dependable 440-amp controller paired with a rugged high-torque motor, it provides consistent, reliable performance.
Motor Features:
For Yamaha G29/Drive and Drive2 48 volt high torque motor (Not a replacement for A/C motor)
19 Tooth Female Spline
Motor has 12-inch overall length
1-year warranty
With upgraded controller:
Speeds up to 18 mph
12.3 HP Peak
Up to 70% increase in torque (High torque applications can damage stock controllers, Navitas upgrade recommended)
Controller Features:
TSX 3.0 440AMP 36-48V Bluetooth Controller
The Navitas app allows you to monitor the vehicle's performance
Built-in speedometer
Gear indicator (Forward, Neutral, Reverse)
One-click Car Lock Out feature
Provides alerts that you can send directly to your technician/dealer by email
New "Cruise mode" for higher top speed (Up to 15% faster)
Speeds up to 23 mph with stock 18" tires
Up to 75% more raw power. Improved hill climb capability with 22/23" tires
Use your stock motor, solenoid and existing wiring
Plug and play installation
Control your regen braking in forward and reverse for added safety when driving or backing down inclines
Use the "lock out feature" to lock in settings to control power and speed
Reliance Yamaha G29/Drive 19-Spline High Torque Motor - 25-518
New Motor Break-In Instructions:
Follow these steps carefully:
1. Initial Drive: Drive the vehicle for 8–10 miles at varying speeds, taking care to accelerate gently during this period.
2. Temperature Monitoring:
Drive on a level surface, such as pavement or asphalt. Gradually accelerate and maintain full speed for 5–10 minutes. Then, stop and check the motor temperature.
During the first 30 minutes of use, check the motor temperature every 10 minutes. To do this, touch the center section of the motor near the aluminum end bell (silver component).
If the aluminum end bell is too hot to touch, stop using the motor and allow it to cool down.
If you can hold your hand on the motor for more than 5 seconds, it is safe to continue driving for a few more miles before rechecking the temperature. Repeat steps 1 and 2 until the 8-10 mile break-in period is completed and the motor operates at a cooler temperature. Following this process will help ensure your electric motor is properly conditioned for long-term use.
CAUTION: Exercise caution while checking the motor. Avoid touching any exposed electrical connections while the power is on.
25-610 Kit, Yamaha G29/DR High Torque Motor+Navitas 440A